anyone have the monoprice Maker Architect

[canadabear07]

have to say seb - you're way way wrong on this.
My ffcx has wooden frame, plastic supports for the heated bed and is all original. Only really gets calibrated when i change the print surface, has around 900 hours of pretty much faultless prints (I don't go in for long high resolution prints), doesn't have vibration issues and has never had levelling issues.
The original 3mm bed will warp - but I just dropped a level 3mm aluminium plate on that and never had any head drag or print level issues since.
The bed is a good way from the arms and even when I didn't know better and was using abs - the heat never effected the levelling.

I would even say that the 4 wheel levelling system is way better than the later 3 wheel system. So much quicker and easier to level with the wheel at each corner setup than the weird 2 at front 1 at back system.

I've got both so i do know :-)

Looks like someone just got burned