Multiple oddities

[TiredJuan]

20151228_140023.jpg20151228_140001_001.jpg
Good, but not great. The raft came out much smoother, and the print is much better overall. Still a little goofy in the bottom layer or two! The top has a little ripple (but not really enough to complain about.)
Also, notice this corner (left side of both images)? It's like that only in this corner of the print, but it happens on each print in this object.

Again, thank you for everything so far, it's already doing so much better.

Any ideas on these layers now? The picture is a bit hard to see, I'm still waiting for the print to cool so the removal doesn't damage or skew anything.

Edit: For those who were wondering, what I did was use a thinner piece of paper. Like that out of a small notebook. I had previously used a piece of printer paper designed for a laser printer.