Results 1 to 10 of 12
Thread: M3D Printer
Threaded View
-
12-22-2015, 12:17 AM #4
Your bed doesn't appear to be heated so yes, you must cover it in blue painters tape. Then you will need to re-level the bed to ensure the correct distance between the tape and the nozzle.
You can google this. The typical PLA temp is between 190C to 210C.
That's a very ambitious print. Start with something simpler and get to learn your printer.
A slicer is the software that slices the model and creates the gcode eg: Simplify 3D, Makerware, Slic3r, Kisslicer, Cura, etc.
Sounds more like bad levelling to me. Take your time and start simple.
The internet is a treasure trove of information. Google google google!!
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help