Results 1 to 1 of 1
Thread: iPhone 4 Stand
-
12-19-2015, 07:55 AM #1
iPhone 4 Stand
Normally I can't showcase my prints due to NDA bla bla. This however is an iPhone 4 stand I designed and printed for a friend.
Designed using Geomagic Design
Printed on my FFCX
ABS
The stand measures 85mm wide, 110mm long and 90mm high.
See here, CA... neither warping nor cracking
20151219_131905.jpg
20151219_131851.jpg
20151219_131809.jpg
And since I got a new (wider) cover for my S4 today I may still print a stand for that... once I can get this eSun silver properly calibrated...
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion