Results 1 to 8 of 8
Thread: CTC Internet ?
Threaded View
-
12-17-2015, 01:57 PM #8
- Join Date
- Oct 2014
- Posts
- 441
Yeah let me know if you find any real info on it. I though about writing CTC and Flashforge and directly asking them. My issue is that my entire upstairs is ran on one breaker, and I have been adding more and more things upstairs. I think it is almost time to figure out how to run a wire to the basement and start a 2nd breaker (The house was built a long time ago, which is why it is wired like it is)
and running my printers and computers and such directly on its own breaker.
I believe the breakers will trip after 15 amps pulled. On the Makerbot site, the Rep2 shows it uses about 2 amps.Last edited by Bassna; 12-17-2015 at 02:04 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion