Results 1 to 10 of 56
Threaded View
-
12-17-2015, 11:47 AM #36
Hey IDefINIte,
As far as I know from the Updates and Videos, the print works as follows:
(With a small sketch; probably one of the worst pictures I've made so far but it shows what I want to show)
PeachyPrinterSketch.jpg
You have a Tank containing some salt water and a wire mesh.
There is a tube going down into the water at the side for the drips.
You put a layer of resin on the water.
You start the dripper and the print.
As the water starts to raise, the printer prints a support structure that encloses the mesh.
Once the top of the layer is above the "grill", the printing of the object can begin.
Cheers,
quertz
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help