Results 1 to 10 of 56
Threaded View
-
12-17-2015, 11:47 AM #36
Hey IDefINIte,
As far as I know from the Updates and Videos, the print works as follows:
(With a small sketch; probably one of the worst pictures I've made so far but it shows what I want to show)
PeachyPrinterSketch.jpg
You have a Tank containing some salt water and a wire mesh.
There is a tube going down into the water at the side for the drips.
You put a layer of resin on the water.
You start the dripper and the print.
As the water starts to raise, the printer prints a support structure that encloses the mesh.
Once the top of the layer is above the "grill", the printing of the object can begin.
Cheers,
quertz
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion