Results 1 to 10 of 31
Thread: Slicing software
Threaded View
-
12-16-2015, 08:40 AM #22
To get info about that, go to this thread on this website:
http://3dprintboard.com/showthread.p...g-Makerbot-3-7
I think it's not compatible with the version of Firmware in our CTC printer,
as are Most Other slicers Not compatible with that Firmware.
But as long as I have version 2.4 working, I'm Happy !
Note: That was mainly about version 3.7 but since then I tried version 3.8,
on a different computer, and it did the same thingLast edited by EagleSeven; 12-16-2015 at 09:08 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion