Results 1 to 7 of 7
Threaded View
-
12-12-2015, 08:41 AM #4
- Join Date
- Oct 2015
- Posts
- 12
For ABS was always running at 230. Since I heard the clicking noises from the stepper, I read around and someone suggested, when in doubt, raise the temperature! So i did to around 250 (or 260?) and that was caused the tip of the teflon tube tube to melt.
Anyways i cut the end off, then flipped it over and everything is working just fine now.
Thanks again!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help