Results 1 to 8 of 8
Thread: Beginner's Question
Threaded View
-
12-07-2015, 05:09 PM #8
- Join Date
- Nov 2015
- Posts
- 7
Hi Adrianl3d,
Being also a beginner I use both ABS and PLA. ABS is a bit of a trial and needs everything set correctly for a perfect plot.
I learned a lot from experimenting with ABS, not just the printing but about my machine and the design software interaction.
Although I have a dual head machine I only set the second head to the correct height after getting repeatable print results.
Printing with PLA afterwards was simple and a lot more forgiving "every one a winner". Try ABS and if you keep at it you will learn a lot more about 3D printing, I certanly did.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion