Quote Originally Posted by SimonF1 View Post
Thanks for the help, i appreciate it.
Yes i had the extruder off and cleaned some very very small flakes but nothing much, then put it all back again and no different.
when i load the extruder it pulls the filament in nice and smooth and ive held it back with some pressure and it managed to pull it np unless i really do hold it back then the extruder starts clicking. so im lost to what can be happening. the print im printing is a print ive done 20 or 30 times so its not that.
Did you clean the guide-Tube, that connects Nozzle to mounting-block ?
(I use a brass-wire, the same size as inside of Tube, to push out everything, after it is heated)

If that is clean and the nozzle Temp is not changing (cooling for some reason),
then it must be binding somewhere at spool or guides from spool ?