Results 1 to 10 of 68
Threaded View
-
11-27-2015, 05:43 PM #26
- Join Date
- Nov 2015
- Posts
- 5
Bruce,
Did you figure this out? I'm having the same issue. G29 results seem to vary quite a bit but M48 results are very consistent and differ from the G29 resutls. And, like you, the difference seems like it would explain my occassional air prints. It seems the two should produce similar measurements. If not, it would be nice to have an explanation as to why.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion