Results 1 to 10 of 24
-
11-25-2015, 07:52 PM #1
Simplify3D - paid but no access ????
Anyone know what's up with Simplify3D?
I paid for the software and the $149.00 has already hit my account.....
But I've received NO emails and can get no access to the software.
Am I doing something wrong?
It says you get instant access after paying?
-
11-25-2015, 10:49 PM #2
- Join Date
- Oct 2013
- Location
- new jersey
- Posts
- 752
yes it usually comes right away but then again your email could be stuck in limbo somewhere or could have been spam filtered out, possible typo or just a email server issue. god only knows. emails can be almost instant or can take a few hrs.
-
11-25-2015, 11:32 PM #3
- Join Date
- Sep 2015
- Location
- San Pedro, CA
- Posts
- 66
Check your spam folder...?
-
11-26-2015, 01:59 AM #4
Have you checked that there was no typo in the adress provided ?
+ the spam folder, yeah.
-
11-26-2015, 05:19 AM #5
yep most likely been spammed off.
they're usually very good.
Although I have found a pretty bad slicing error.
Printed a widget - and no I have no idea what it's for, friend just asked me to see if I could make one.
It's basically a cylinder with a hollow section going up the middle to a solid end with a much smaller hole in the centre.
Now instead of doing a bit of bridging at the first solid layer with the small hole and then printing the hole surround on the support. it printed the hole surround first - in mid air. then filled in the bridging. doh !
subsequent layers are all fine.
I'll post it on the s3d forum. just need the algorithm tweaking I reckon.
-
11-26-2015, 06:14 AM #6
The Receipt for the payment arrived. The link to download the software....still hasn't.
Checked every spam and junk folder.
That rules out spam etc and bad email address. They simply never sent the link to get the software. But they got the MONEY !!! ;-)
If they're out for a long holiday, looks like I won't be getting anything done over mine.
I'll have to wait until they return. Bummer x 10
-
11-26-2015, 07:35 AM #7
If I remember correctly, mine took over 2 days to complete.
-
11-26-2015, 07:52 AM #8
-
11-26-2015, 08:02 AM #9
Well, it's Thanksgiving so they aren't going to be in today of course.
They may not be back until next week. No telling.
Meanwhile, I'm studying Gcode and trying to learn enough to use ReplicatorG. (silver lining)Last edited by Ward; 11-26-2015 at 08:09 AM.
-
11-26-2015, 09:13 AM #10
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help