Odd Printing Question

[EagleSeven]

I have a FFCP clone.

It will only print up to 8.9" height x 5.7" width x 5.9" length

Unfortunately I would like to print something that is long and flat 6.5" long x 3.5" wide x .125 thick"

Since I obviously do not have the width needed, what would happen if I tried to print that object On EDGE ?
I'm assuming I would have warp city and it'd be about as wavy as the surf on a windy day.

Do I have no choice but to buy a 2nd 3D printer with a larger build volume to get that extra .6 inches?

Just rotate the object to fit the bed-space diagonally , in the slicer software, if it will fit that way ?

Go to this thread, to see what I did to solve those problems:
http://3dprintboard.com/showthread.p...ender-brackets

Our bed is now 11" long.
(There's a picture of the extenders in that thread but you must click the website's hidden-pages to see it ! ??? )