Results 1 to 10 of 14
Thread: 3DSimplify crashing occasionally
-
11-23-2015, 07:02 AM #1
3DSimplify crashing occasionally
Do you ever have 3DSimplify to crash?
I only had it one day but during that time it crashed probably 4 times.
I don't have program crashes on my computer very often at all. VERY rare.
But 3DS was crashing quite a bit relatively speaking.
Just wondering if this is somewhat normal for the software?
btw....Windows Vista Ultimate 64bit
-
11-23-2015, 09:33 AM #2
is this a bought version - or the PIRATE version of s3d ?
And no it shouldn't crash - but then vista is probably the worst operating system ever released. And I'm including windows 8,10 and me in that :-)
And 64bit vista - come on, di you just look up: 'worst and least compatible operating system ever' and then download a dodgy version ?
Be grateful ANYTHING runs, ever :-)
-
11-23-2015, 11:07 AM #3
Bought....well refunded actually now.
lmao
Darn computer has been ROCK SOLID for years no matter what I've thrown at it. Go figure.
I "suspect" I picked up malware somewhere recently because in the last month I've had an uptick in stupid behavior.
Oh, a Windows Update....THAT is the "malware" that messed it up.
-
11-23-2015, 11:22 AM #4
Software crashes happen. But 4 times a day... I'm with CA... sounds like a Vista issue...
-
11-23-2015, 11:29 AM #5
Send the windows event logs and dump files to S3D
-
11-23-2015, 11:33 AM #6
-
11-23-2015, 12:19 PM #7
Anything else crashing? Resources through the roof? If not its unlikely to be malware...
-
11-23-2015, 01:29 PM #8
-
11-23-2015, 02:45 PM #9
- Join Date
- Jan 2015
- Posts
- 445
try running it in compatibility mode.
-
11-23-2015, 04:56 PM #10
- Join Date
- Aug 2015
- Posts
- 256
Simplify crashes on me occasionally when slicing, not often enough to worry about. I'm using windows 7 64.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion