Results 1 to 5 of 5
Threaded View
-
11-23-2015, 12:01 AM #3
- Join Date
- Jan 2015
- Posts
- 306
Hi Roxy, I am the wrong person to ask about the output response and internal circuitry diagram. But I do remember seeing people use this probe, with ramps + arduino machines and it literally was plug and play (or close).
I just want to know, if it is more accurate and repeatable than servo/microswitch.
By the way Roxy, what type of microswitch do you use? Do you use one with a roller at the end of it? How long an arm should I go on the switch? What is the most repeatable switch? I guess I am asking.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)