A Lot of talk here about flashing the chip and I already have a couple of cartridges with extra filament. So... how do you go about doing this or where on the XYZ site do you get the information? I already have an open ticket with them about this along with a question about the printer "Skipping" or not extruding the filament. Just my opinion but it seems if you "cancel" a print, the counter still thinks you have used the filament so after 3 or 4 cancellations you might have a enough filament to make a new part but the machine will not allow it. Again, any help or information on how to use the extra filament would be appreciated.
Thanks in advance...
Drafter1981