Actually just tried setting up the malyan with repetier and slic3r based on specs. Repetier has nothing to do with code flavor but slic3r has settings for both repG and makerware.

Doesn't matter, I decided against the malyan because of -
#1 85c bed temp
#2 heavy ass extruder makes resonant waves in prints at higher speeds
#3 I think I rather a mixing extruder over dual nozzle.
#4 plastic belt pinions/pulleys

This printer would be sweet with the extruder motors on the back instead of gantry and marlin firmware.

With the $170 per printer I save by buying fabrikators, I can buy a cyclops extruder and all necessary hardware to run it.