Results 21 to 28 of 28
-
11-16-2015, 06:24 PM #21
-
11-16-2015, 06:27 PM #22
Ok. Thanks for the feedback. I think all my current designs are pretty simple and should be very easy for the printer to build. I hope. But like you say, experience will correct if I'm wrong. I hope I haven't underestimated the skill required to take things from design to build.
-
11-19-2015, 01:37 AM #23
- Join Date
- Nov 2015
- Posts
- 2
other than build volume - nope no reason whatsoever not to buy one.
http://www.casesam.co.uk/category-ga...-cover-15.html
http://www.casesam.co.uk/category-ga...-cover-10.html
http://www.casesam.co.uk/category-ga...-cover-33.html
Last edited by UAVUHNM; 11-20-2015 at 02:51 AM.
-
11-19-2015, 06:56 AM #24
Maybe I should have bought the FFCP after all.....the MonoPrice clone seems to have had a catastrophic extruder failure on the 3rd print :-(
I'm so sad. I did two prints yesterday, the first done with ReplicatorG (awful) and a 2nd done with Simplify3D (fantastic) and was very excited.
Extruder malfunction (overheat then total extruder failure) on the third print this morning.
Waiting for MonoPrice to open this morning so I can call and see what they will do.
-
11-19-2015, 03:29 PM #25
- Join Date
- Aug 2015
- Posts
- 256
-
11-19-2015, 03:57 PM #26
-
11-20-2015, 03:21 PM #27
- Join Date
- Aug 2015
- Posts
- 256
-
11-20-2015, 03:32 PM #28
- Join Date
- Oct 2014
- Posts
- 441
I mean hey, if they are fixing it for free, not so bad of a deal. Still saved a lot of money on that compared to a FF.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion