Results 1 to 6 of 6
-
11-07-2015, 03:39 PM #1
..........
If a mod see this, feel free to delete.
Thanks much.
TiLast edited by Fantastic Brass Ninja; 11-22-2015 at 11:02 PM.
-
11-17-2015, 10:23 PM #2
Post edit.
Last edited by Fantastic Brass Ninja; 11-22-2015 at 07:27 PM.
-
11-18-2015, 12:13 PM #3
-
11-18-2015, 01:50 PM #4
HA! Yes, I did somewhat. I have gotten to where I can send commands from Repetier, but there are still some things not 100%. Endstops, all axis only move up, ect.
I might like to start another thread, but after how stellar this one was, I'm not sure I'd need too.
-
11-18-2015, 08:43 PM #5
That's a good looking Kossel. I recommenced not using small gauge wire too or from your PSU. An old, 16awg PSU cable can be sacrificed for much higher quality power wire:
http://www.monoprice.com/Product?p_i...sUMaAnu18P8HAQ
Don't use that crappy 24awg endstop wire for any power wiring. I've seen phoenix connectors burn up because of improper wiring.
-
11-22-2015, 07:01 PM #6
Thanks for the suggestion, Lucky! Duly noted.
Last edited by Fantastic Brass Ninja; 11-22-2015 at 07:27 PM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion