Results 11 to 17 of 17
-
11-16-2015, 02:06 AM #11
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
Cura cannot talk to the printer. The printer needs an X3G file and Cura cannot make that, hence the need to convert from Gcode to X3G using RepG.
-
11-16-2015, 03:15 AM #12
- Join Date
- Nov 2015
- Posts
- 9
Hello...
That i know, i used a file converter from here... http://www.thingiverse.com/thing:81425
Using that converter the printer acts like i said...
Regards.
-
11-16-2015, 03:29 AM #13
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
I have spent hours trying to get that converter to work and had no success at all. A lot of people use it without any problems but not I.
-
11-16-2015, 05:16 AM #14
- Join Date
- Nov 2015
- Posts
- 9
Here is a new print... temp used 240 heat bed 55, no stick glue using makerware 2.4... i had to sand out some excessive material in some places to look like this...
20151116_105157.jpg20151116_105240.jpg20151116_110122.jpg20151116_111535.jpg
-
11-16-2015, 10:35 AM #15
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
Well it is a lot better but I still think it is under extruding.
-
11-16-2015, 12:14 PM #16
-
11-16-2015, 12:30 PM #17
- Join Date
- Oct 2014
- Posts
- 441
Looks like it warped pretty bad. I had great luck with kapton tape and a very very slow first layer speed with ABS. I've just switched to glass bed with hair spray and thats working good also. Also, switch to Simplify3D
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion