Results 1 to 10 of 17
Threaded View
-
11-13-2015, 09:18 AM #3
- Join Date
- Nov 2015
- Posts
- 9
Hello...
the problem about the temp i think is beacuse of the pre heating settings that is set by default to 230 for extruders and 110 for the bed on sailfish 7.7 im goind to put all to zero and see if i can control the temp. with makerware...
But now i have a some doughts about bed leveling... as ive read about you have to use a piece of paper... so... i get the extruder to front center and level the bed until it scratchs the paper... do the same to left... then right side... but when i go back to front center i dont feel the scratch on the paper... is that normal? the same happens at the back.... for me to feel some grip at center the left or right is too tight!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help