Results 1 to 10 of 101
Thread: I need some serious help
Threaded View
-
11-13-2015, 01:28 AM #28
- Join Date
- Oct 2015
- Location
- Great Falls Montana
- Posts
- 52
https://www.dropbox.com/s/o0396u2ikl...02201.jpg?dl=0
https://www.dropbox.com/s/fk4pot8zpl...02209.jpg?dl=0
https://www.dropbox.com/s/850oy15fpu...02220.jpg?dl=0
https://www.dropbox.com/s/y6g216raat...02229.jpg?dl=0
Belive it or not , that first cube cal. was printed using almost the same slicer settings , and no scaling on either , guess thats the difference in proper calibration. woot , go me (and you guys for helping)
I just tried doing a dry run on the delta calb. tool and at the extreme edges between towers (not at the towers) the head is lifted probably 6 mm ish off build plate.... I have now adjusted the horizantal rod and diagnol rod to get the head to be the same height at towers as its at at the middle at z0 , what do i do when it lifts between towers (while making a circle) I can post a video if you guys need me to .
Edited : Im going to bed , talk tomorrwLast edited by Nickschaos81; 11-13-2015 at 01:30 AM. Reason: cuz im going to bed
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help