Results 1 to 5 of 5
Threaded View
-
11-12-2015, 01:49 PM #4
- Join Date
- Jun 2015
- Posts
- 14
Allow me to add yet another possibility, that your print is getting too hot?? You could try cooling down the ambient room temperature.
Artifacts like these can show up on the overhangs and sometimes faces orientated away from your print cooling fan. If you are not using one already try blowing a room fan gently over the print or open a window and see if that improves your print.Last edited by Nihonddd; 11-12-2015 at 02:10 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion