Results 1 to 10 of 21
Thread: MF Pegasus Print Quality Issues
Threaded View
-
11-06-2015, 09:23 AM #15
- Join Date
- Feb 2015
- Posts
- 371
I am curious to see. Adding the SSR helped my prints come out nicer. I didn't have the banding to that degree however. I did at first. The firmware provided from Colin had me over extruding quite a bit. Only once I had my machine calibrated better and then adding the SSR was I happy with the prints.
I think in this case adding the SSR will help. If you still have banding issues (The may be smaller) you might have a extruder calibration issue too. I still chase that number all the time. It is why i have modified my firmware so that the knob on my display adjusts the extruder multiplier instead of the speed while printing.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help