Quote Originally Posted by FDM_Process View Post
Well that makes more sense because that was how I had my solidoodle setup. However, I only switched to a SSR because my original heated bed died and I replaced it with a more powerful one.

I'm not seeing how this would cause a z-banding issue like the one imaged above, especially near the top of the print where the heated bed would have absolutely no bearing on the actual print.
It doesn't matter if your print is 10mm or 10X10^10mm's tall. If the base (Heatbed) fluctuates up and down by 1-2mm's then the whole print is moved up and down 1-2mm's.