Results 1 to 2 of 2
-
11-05-2015, 03:33 PM #1
- Join Date
- Jun 2015
- Posts
- 6
I need a good coating for all-around use. High-build polyurethane?
I have searched the forum, and didn't find too many recommendations besides XTC-3D.
Polyurethane seems like the best thing for me. However, the regular stuff is too thin. After 2 coats, it did not really fill in the crevices. It seems to reduce as it dries and also scratches off.
I asked at the hardware store about a thicker polyurethane and was told to get High-build. It only seems to be available in $35 cans, so I wanted some opinions.
I do not like the idea of an epoxy coating that has to be brushed on.
Here are the uses I want it for:
- Can be applied by dipping. Doesn't need to be brushed on. This is so I can coat interior spaces like tubes or bottles.
- fills in layer crevices, preferably with one coat.
- waterproofs surface
- food safe
If anyone knows about some good products that I haven't mentioned, please post them. Also please post any knowledge you have about high-build polyurethane.Last edited by Wade3; 11-07-2015 at 11:47 AM.
-
01-25-2019, 08:42 AM #2
Check out Alumilite Crystal Clear Casting resin, and the Masterbond epoxies.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion