Results 1 to 10 of 21
Threaded View
-
11-05-2015, 10:05 AM #15
- Join Date
- Oct 2015
- Posts
- 11
So I've been using Makerware 2.4 on Sebastian's recommendation for a bit now. It fixed the issue of the bed dropping after the priming bead, but I find that I get badly sliced models pretty often now. Specifically, for some horizontal holes or other through features, it'll make them into slots that extend out of the model. Here's an example.
Before slicing...model.jpg
After slicing, in the preview...sliced.jpg
So I'm trying to find Makerbot Desktop 3.6 which, Sebastion tells me, will also have the correct behavior at the beginning of a print, but I'm hoping will also slice better.
Anyway, I can't for the life of me find where to download that. There's a post on this forum that announces its availability, but it just goes to makerbot.com which only has 3.7
Any suggestions?
Thanks!!!
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion