Results 1 to 10 of 18
Thread: new to 3D printing, help please
Hybrid View
-
11-02-2015, 12:18 AM #1
- Join Date
- Sep 2014
- Location
- Brummen, Netherlands
- Posts
- 265
Make of 3D printer?
Type of filament?
Dimensions of object?
Heated bed and nozzle temperatures?
Optional: picture?
Without the above there is not much help we can give you....
-
11-04-2015, 05:45 AM #2
lmao - check the forum section before asking what printer :-)
Sounds like the bed material isn't as sticky to pla as it should be.
So you're getting a slight warp. Cheap pla will warp a bit.
Try rubbing a gluestick over it - pla loves pv-alcohol (the main active adhesive in glue sticks)
That will let the pla stick much better to the bed.
A couple layers should do to start.
I usually run the stick over the bed before a print and after removing one from the bed - that tidies up any gaps from pva sticking to the print.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion