Hi Davo,

Thanks for the reply! I am currently on the latest Repetrel with the new firmware as well. I had done the import all settings and am currently using the 0.5mm extruder. I am currently using the slicing settings as such:

Print: 200 microns - .35n no support
Printer: Hyrel System 30M
Filament: ABS 230C AUTOfan

I will try increasing the prime and unprimed steps and dwell time and flashing the head. I may take you up on that team viewer session this coming week. Thanks! I will send you some g-code for my next print as well later today hopefully.

Sincerely,
RD_3D