Hi!

I was about to remove the resistor R29 so that I can get accurate temperatures with the V6 but it looks like there is nothing there? It's a white dot. I'm looking at the bottom of the board below the ATMEL chip - is this the right place? r29.jpgI'm stumped & have no clue what to do now.

EDIT: I've done some resistance checks on the resistors in the picture I've attached . This is what I found:

R125 - ON:99ohm OFF:99ohm
R27 - ON:996ohm OFF:549ohm
R29 - ON:NO CONTINUITY OFF:656ohm

EDIT 2:Or am I completely off and it's on the breakout board?

Thanks in advance
Brad