Results 111 to 118 of 118
Thread: New Matter updates
-
10-20-2015, 09:44 PM #111
- Join Date
- Dec 2013
- Location
- Georgia
- Posts
- 934
Well, I've finally finished out my free half-kilo of SUPER FREAKING PINK filament, unfortunately I wasn't paying attention at the end of the spool and I got to experience clearing out my first jam...
Long story short, it was a heck of a lot easier than with a Makerbot, the hot end unplugs from the head unit and simply unscrews (they even have an instructional video on youtube for it) after that it's a simple matter of plugging it back in, heating it back up while unscrewed and pushing the filament the rest of the way through (with proper protective gear, of course) The whole process took about 5 minutes.
-
10-27-2015, 10:57 PM #112
- Join Date
- Mar 2015
- Location
- California
- Posts
- 10
Check this out:
https://www.youtube.com/watch?v=k_049B56ifQ
-
10-28-2015, 06:18 PM #113
- Join Date
- Oct 2015
- Posts
- 12
Is there a firmware change log anywhere? It would be nice to know what each firmware release changed instead of guessing and looking for differences. (i.e. just updated to 0.2.0)
-
10-28-2015, 09:33 PM #114
- Join Date
- Oct 2015
- Posts
- 2
Ditto! Your early users really need this. I attempted to print the 2-sided pumpkin from the store, and after something like 18 hours, it appears to have simply stopped. Is that something that's likely to be fixed? What about the wifi problems? Are they fixed?
-
10-29-2015, 12:15 PM #115
- Join Date
- Mar 2015
- Location
- California
- Posts
- 10
-
10-30-2015, 09:38 AM #116
- Join Date
- Oct 2015
- Posts
- 2
Well, you specifically asked about sound, and I didn't include the sound, and it's sped up 8x, but here's something: https://youtu.be/K1uD0gRSx0Y
-
10-30-2015, 01:02 PM #117
-
10-30-2015, 06:00 PM #118
- Join Date
- May 2014
- Posts
- 16
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help