Results 1 to 10 of 20
Thread: Extruder Upgrade assemblies ??
Threaded View
-
10-27-2015, 11:02 AM #17
Well, the way I understand it is that stepper-motors are Not rated at a fixed voltage,
like 12 or 24 volts,
but are rated at a voltage Range, like 3 to 25v or 5 to 30v, etc.
and usually only the minimum voltage rating info is given , like 3 or 5 volts.
So they should operate on a higher or lower voltage, as long as it's in that Range of voltages.
I've not tried their extruders yet, since the old ones are working great now,
but I plan to soon.
Thanks for the Info,
Note: I have verified that seller is correct about there being 2 versions of connector wiring in Nema-17 motorsLast edited by EagleSeven; 10-27-2015 at 11:26 AM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion