Results 1 to 10 of 15
Thread: Base printing problem
Threaded View
-
10-24-2015, 12:18 PM #13
I found the perfect combination
1. I cover my platform with blue tape
2. I used a preheat just to make the tape stick well to the platform
3. Then I sent just a raft peace of square and level the bed during printing, so you can adjust any anomalies. This help me to get to the perfect level.
4. I spray a thin layer of LOCTITE Spray adhesive over the blue tape, it works great!
5. This is my print result:
PRINT.jpg
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion