Quote Originally Posted by Nickschaos81 View Post
it doesnt go quiet as far, still got a gap maybe .5 ish

Would it be better if I set my distance higher then i actually have that way i can see the difference it takes to get tension on a sheet of paper at each point?
No you can just eyeball it for now.

If you have the same height issue (too high) at G1 Z0 X-30 Y-50 then you need to make your smooth rod offset smaller by 1mm. I believe with RC Marlin it's: M666 Rxxx. Don't forget to save to eeprom with an M500 and do a G28 before testing again.