Results 1 to 10 of 32
Thread: Any Problem Contact Me
Threaded View
-
10-19-2015, 10:53 PM #26
- Join Date
- Aug 2015
- Posts
- 12
Is it normal for about 3mm of the model to be cut off from the bottom of the turntable up? Every scan I have done so far the model gets chopped off even when I have the object straight up with no inside pockets. For example when I scan a bottle of wood glue, everything from under the barcode is chopped off. I have the spacing correct to the mat and the angle as shown in the video. Is this a calibration error? Should I run it again?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help