Results 1 to 4 of 4
Thread: 3D Printing Podcast!
-
10-13-2015, 10:01 PM #1
- Join Date
- May 2015
- Posts
- 2
3D Printing Podcast!
Hello All,
For a while now I have been scanning the threads looking for the most asked about topics. The reason I have been doing this is because I would like to create a podcast or webinar where the most popular 3D printing questions are asked and answered . My question to all of you is: What topics would you want discussed in these podcasts ?
These topics could range anywhere from beginner to expert or even 3D scanning to the best 3D software.
Let me know what you think.
-
10-14-2015, 07:56 AM #2
My most often asked Question is:
'Where can I Get the Free Stuff' ?? LOL
-
10-14-2015, 08:46 AM #3These topics could range anywhere from beginner to expert or even 3D scanning to the best 3D software.
-
10-16-2015, 03:16 AM #4
A video that would answer the typical newbie questions on this forum so we could direct them to your vid instead : explain bowden / direct drive ; explain core xy; show what is a delta ; how to detect and correct not tight belts ; advantage of Z probe to perform a G29 ; a tuto on various extruder gens/heatbed/closed frame and the relation to usable material ; heatcreep ; filament material, bed and adherence ; testing temps on a new filament.
for slightly more experienced newbies :
demo on bicolor and how to set it up ( with a dual extruder and without)
But this is just to avoid typing the same stuff over and over. What would actually interest me or what I could contribute to is :
Demo of tolerances to apply on fittings.
Demo on advanced post processing methods and cheap kits (sandblasting ?, electroforming ?)
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery