Results 1 to 7 of 7
Threaded View
-
10-14-2015, 11:38 PM #5
Yes, Micromake has this strange Z-probe, which actually is the whole extruder hitting bed, then moving extruder upwards releasing a micro switch.
Seller told me the marlin firmware was the old one, so the correct one is the one i flash using cura.
Also he told me to turn the belt-pieces upside down to correct the movement direction problem.
Gonna try this later and see if it fixes the home problem.Last edited by Stigern; 10-15-2015 at 06:09 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion