Results 1 to 10 of 18
Threaded View
-
10-09-2015, 01:23 PM #5
- Join Date
- Oct 2015
- Posts
- 7
Second impression:
Second test print worked like a charm. New Matter replied saying that if I leave the clear enclosure off (which I had done) the space can be too cool and cause problems with the print not adhering to the bed. So from now on I keep the lid on.
They also said that the louder than expected calibration routine was probably due to the bed being slightly crooked on the rods. Got the second print I got it on straight and it was much quieter.
At the beginning of the second print when it "wipes its nose" on the side of the bed, it still strung a very fine line of filament to the print area and it stick under the print. Is this normal?
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help