Results 1 to 10 of 15
Thread: Just ordered my CTC :D
Threaded View
-
10-09-2015, 07:31 AM #8
- Join Date
- Oct 2014
- Posts
- 441
So the printer just arrived last night. Got it all set up, seems to be working pretty good so far. I did have one crack in part of the frame from shipping. I will be emailing them about it, hopefully they will send me a replacement frame part. Eagle, I printed out the parts for that filament+wire guide, but I don't have those M6 push-in connectors yet, probably not for a week or so. I see what you mean by the wires just are basically flopped down. Still safe to run the printer for awhile until I get those push in connectors? Also the firmware its running is "The creator 1.0", now I use Sailfish on my Flashforge, should I be upgrading the firmware to Sailfish on this as well? Thanks!
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion