Quote Originally Posted by EagleSeven View Post
But have you measured temp of the Motors while printing??
I have and they get way too hot without a fan blowing directly on them.

I certainly would Not want my Favorite motors hanging about in that Hostile Environment
of an enclosure !

Aqua-net is the Best !!!
Just the Correct amount of 'Holding Power' !
You stated before that you print with PLA so obviously you don't need a heated chamber, or a very hot bed for that matter.

If you're printing large abs parts without an enclosure your'e going to get splitting and warping no matter how good your bed-adhesion is.

The motors tolerate 40-50c temps just find, if they didn't mine would have failed long ago.