Close



Results 1 to 6 of 6
  1. #1

    PLA extrusion not consistent

    I have an airwolf HD. I'm trying to print on black pla from matterhackers, but it wont extrude evenly. I'll try to extrude into open air for 100mm and it will start extruding, but then extruder starts clicking for a couple of seconds then it continues to extrude normally and then it repeats. I've tried increasing the temperature all the way to 220 but still doesn't work. Any help is appreciated

    Thanks.

  2. #2
    Staff Engineer LambdaFF's Avatar
    Join Date
    Jan 2014
    Location
    France, Aix en Provence
    Posts
    1,137
    Hi, have you tried looking at the extruder gear ? If it is unclean, it may increase torque at the same spot every turn, thus creating your issue.

  3. #3
    I have cleaned the extruder assembly but no change. I'm thinking that maybe the hobbed bolt might be damaged even though I couldn't really tell. I have ordered a new one so now I just have to wait and see

  4. #4
    Student
    Join Date
    Sep 2015
    Location
    NE Georgia
    Posts
    8
    Have you adjusted the VREF of the extruder motor control Stepstick?

  5. #5
    Staff Engineer Davo's Avatar
    Join Date
    Nov 2013
    Location
    Atlanta, GA
    Posts
    1,085
    Follow Davo On Twitter Add Davo on Facebook Add Davo on Google+ Add Davo on Shapeways Add Davo on Thingiverse
    Have you measured the filament for consistent diameter?

  6. #6
    fjnamtiw, I actually don't know to what you're referring to. How do I go about doing that and what does it do? I have put in a new bolt and feeding tube. I do have to mention that I bought it used and that the 3d printed parts for the extruder don't look in the best shape. I have been able to get some good prints on abs although I have had the same problem once in a while

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •