Results 1 to 10 of 33
Threaded View
-
10-02-2015, 06:16 AM #30
- Join Date
- Aug 2015
- Posts
- 4
Since my last post above, I've had to replace a few electronic pieces as well as new rods and bearings. I'm not sure where you're buying from, but I strongly suggest going through a reputable outfit. I chose the "cheap" route buying from China and I'm paying for that mistake. I've invested about 8 hours building it, and 20 hours troubleshooting/calibrating, and I still have not had one successful print! I should have just bought a Taz5.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion