Results 1 to 7 of 7
Thread: Platform Failure?
-
08-10-2015, 07:48 PM #1
- Join Date
- Oct 2014
- Posts
- 441
Platform Failure?
Just got home from work and had this message on my screen, "Platform Failure! Temperature reads are failing. Check wiring." Now I get a NA and no heating on the bed when starting a print on the temp screen under bed. Any tip's or advice if you have had this happen before before I go tearing it apart?
-
09-26-2015, 02:31 PM #2
- Join Date
- Jul 2015
- Posts
- 19
any news on this? I'm now experiencing the same problem
-
09-26-2015, 02:43 PM #3
- Join Date
- Oct 2014
- Posts
- 441
Well I did e-mail them, and they just asked for my serial number on my printer. But all I had to do was turn the printer off and on, wiggle the wires on the bed plate and it was working again. So I never did e-mail them back about it.....I've had it happen about 3 times, but each time just doing that fixed it. Hope it works for you
-
09-26-2015, 03:06 PM #4
- Join Date
- Jul 2015
- Posts
- 19
yup, just checked the wires on the MB, gave them a wiggle and tightened them down. Works fine.
Thanks for posting!
-
10-01-2015, 08:48 AM #5
- Join Date
- Oct 2014
- Posts
- 441
-
10-04-2015, 01:44 PM #6
- Join Date
- Jul 2015
- Posts
- 19
-
10-04-2015, 02:09 PM #7
well as I'm currently using mine to heat up an ipad - supposedly to soften tghe glue so i can get the bloody screen off.
I hope mine doesn't break :-)
And for the record heating up the screen just makes the glue stickier - but I feel I'm torturing the ipad, so I keep doing it :-)
If anyone ever asks you if you can replace a screen on an ipad 4 - SAY NO !! and run the other way.
I didn't. :-(
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion