Results 1 to 9 of 9
Thread: Geeetech G2s Printer Kit Review
Threaded View
-
09-29-2015, 05:43 PM #6
The corner anchor is just positioned on the grid at the right spot in Slic3r. You would replicate it 6 times if you are going to use it and put one under each leg. Once the part is printed and off of the glass, you just take a razor blade and slice it off.
I'm going to print up your rod_end_shims(). I have a lot of wiggle on my effector.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion