Results 1 to 10 of 19
Thread: FIlament jam/grind at height.
Threaded View
-
09-25-2015, 09:25 AM #18
I have seen that happen. I have a roll of PLA that needs 210 degrees and if it is a long print and the nozzle is only putting out a tiny amount of filament... It can plug. And the other thing that happens is after a print, the printer shuts everything down. Half the time I have to extract the filament and cut off a few inches because it ends up being too big to feed through the extruder. The good news is that roll is almost used up!!!
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion