Results 1 to 10 of 25
Thread: Marlin 1.1
Threaded View
-
09-25-2015, 09:21 AM #9
If the switches are wired in series, you want them to be in the "Normally Closed" position when printing and not at an end stop. If the switches are in parallel you want them to be in the "Normally Open" position when printing and not at an end stop. But regardless of whether they are in series or parallel, you want both switches to be in the same "Normally something" state when they are away from end stops.
If you don't have them setup this way, you are asking for trouble!!!
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion