Octoprint with FFCreator Pro is this going to work ?

[obecny]

i'm running this setup and it works great.
the only gotcha's i ran into was to make sure you set a login and password when you first set it up.
i skipped it the first time around since it will only be local. but nothing worked right.
also i am using the octopi pi image.

another thing is when i upload a gcode and load it to the octoprint the object in gcode viewer is off the bed on the right front
is there something wrong with my settings ?

[warkmal]

The gcode viewer shows the print relative to the bed based on OctoPrint's printer profile in its settings. Probably you need to tell it that your origin is in the center since that is the Makerbot way and opposite to the default for most reprap printers.