Results 1 to 10 of 10
Thread: Another Corner Curling Up Issue?
Threaded View
-
09-17-2015, 04:05 PM #6
I interpret this to mean the fan is "pushing" air onto the hot end heatsink, which would be consistent with what MakerFarm and e3d both tell you to do. The boxed-in bottom of the i3/i3v X-carriage leaves nowhere for the fan airflow to go except back down onto the print. For ABS, that has led to warping/adhesion problems for at least some people. Flipping the fan around so it pulls air up from the print area, through the heatsink, and exhausting it out the fan helps.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion