Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 23

Thread: Shifting layers

Threaded View

  1. 09-15-2015, 10:52 AM #18
    eXodus
    eXodus is offline
    Student
    Join Date
    Jul 2015
    Location
    Bergeijk, The Netherlands
    Posts
    12
    Quote Originally Posted by jimc View Post
    Ill say it again. Its highly probable that its the arduino version you are using to compile the firmware with.

    Also your accelleration and or travel move speed is too high
    The software version you mentioned before was it the windows software or the marlin firmware?
    Cause I have absolutely no idea, as I'm new to this.

    Edit: just found out the firmware the printer is running on is Repetier, does this have the same problem with the arduino?
    Last edited by eXodus; 09-15-2015 at 01:53 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules